Technical questions for the MPC2000xl and the MPC2000
User avatar
By Johnnyd0205 Sun Jun 17, 2018 5:53 pm
hello,
I bought a mpc 2000xl from a previous owner and their was a lot to repair on it such as the pad sensors, screen mount, etc. when replacing the pad sensors, i noticed their was a bent pin on the pad sensor socket which caused a row of pads not to work. Is there a way that I can either fix it or replace the part? I’ve tried looking for a replacement socket to solder onto the board but can’t find it anywhere. Any help would be appreciated!
Thanks
User avatar
By JUKE 179r Sun Jun 17, 2018 9:09 pm
I’ve taken a scribe and carefully pushed up on the pins to make contact to the sensor sheet.
User avatar
By richie Mon Jun 18, 2018 12:10 am
Just so everyone is on the same page -- Can you take a picture of the 'socket' you're talking about?