Figured out a little trick with the Fat Pads upgrade!

So you know the little rubber corx that aid in the sample trigger response....btw, DONT put them directly on the sensors like MPC-Stuff suggests. I mean it doesn't harm anything but I had double trigger nightmares with it, at least I did anyway. I stick my corx to the pads themselves, which works better for me, but I was still getting double triggers, not real bad but more than I wanted to deal with. I figured out its because the top side of the rubber corx are a little sticky themselves, just due to the quality of rubber they use, which is a good quality.

They were sticking to the sensors a little which was helping the double trigger. So I took some of my wifes baby powder and one of her little makeup brushes and just dusted each corx with the powder. Used my compressed air to blow off any extra and it works like a CHAMP. Try it out if your having this same issue.

you're joking

I thought the corx were always stuck to the bottom of the pads and never on the pad sensor itself?

MPCStuff states either bottom of pads or on sensor sheet.

No joke! If you find you put a little too much just use rubbing alcohol to restore the rubber back to original.