Exchange tips and tricks for the Akai MPC4000
By Fylthy Thu Dec 22, 2016 12:40 pm
I've read all I can, addendums, posts, searched best I could and I can't figure this out.

Perhaps I'm wrong, but I think that a few years back I had a set-up where the q-links would only effect the currently selected track. So, say on the main screen I have Trk 1 in view, then turning the qlink knobs would only effect the part (program) assigned to that track, change to Trk 2 (still on the main page view) and now they are only effecting the program on that track. Same set of Q-link destination assignments (pan, cutoff, decay... whatever is assigned in the qlink "receive" page) but only effecting one track/part (program).

Am I on drugs? Did I imagine I could do this? Best I can tell now is that I'd have to go into the qlink setup each time I want to start using the qlink knobs on a different part, and cursor around the page to adjust all six assignments for a different part. That can't be right, can it?