Forum to discuss all matters relating to the MPC1000 and MPC2500 operating systems created by 'JJ' (all versions).
By theviirus Tue Feb 27, 2018 9:25 am
Hi, so I'm having a problem where my input thru settings arent being recalled/saved properly. Mixer settings, program settings, midi settings, all route properly, but input settings won't stick.

I was under the impression that input thru settings are saved with the mixer settings (inside the "all songs and seqs" file). Ive been searching the forum, the JJOS website, and the internet and havent found much clarifying this for me. I havent found any bug notices about this either.

Does anyone have this problem right now?

I use 2 synths with my mpc1000, would like to route them through via L+R, each with individual mixer levels and FX send levels. I would like these settings to change depending on the song I load. Is this possible?
By theviirus Wed Feb 28, 2018 5:09 pm
Ok. Ill post screenshots and files later showing that even in new projects saved separately, input thru settings are not being saved/recalled.

Is anyone else experiencing this behavior?