By jackal_Mask
Fri Feb 03, 2017 12:46 am
Hi there,
I'm successfully able to load samples onto pad, I can hear them in these modes:
- preview, when loading to a pad
- trim
- if it's recorded in a sequence
However, if the sequence is not playing, I press the pad and hear nothing? Also when recording the sequence, I don't hear anything from the pads, but when I play it back after recording, the sample plays.
I have tried
- making sure "full" level is on
- making sure it's 16 bit / 44000 hz
- shortening and simplifying sample names
Any help would be appreciated! I'm trying to make sure it's in good condition so I can sell it (in case anyone's interested!)
I'm successfully able to load samples onto pad, I can hear them in these modes:
- preview, when loading to a pad
- trim
- if it's recorded in a sequence
However, if the sequence is not playing, I press the pad and hear nothing? Also when recording the sequence, I don't hear anything from the pads, but when I play it back after recording, the sample plays.
I have tried
- making sure "full" level is on
- making sure it's 16 bit / 44000 hz
- shortening and simplifying sample names
Any help would be appreciated! I'm trying to make sure it's in good condition so I can sell it (in case anyone's interested!)
^^MPC500^^