JJ OS Bug Reports (ARCHIVE)

perhaps - anything to do with qlink not being at zero (reset) before u recorded....? if so (as happens to me sometimes) when restarting the sequence after recording, then the qlink gets reset on restarting the sequence....and u get two different pitches one before / one after.

the program doesn't have qlinks assigned.

Only thing i can imagine else is the sample rate not being 44.1k

all samples in the program are 44.1kHz/16bit. if i play the pads it's fine, if i play the sequence, it's out of tune.

funny thing is: i saved the project, and now i've gone back to it, all is fine!

your mpc , mr modnar , need a good seeing to.

: 0

rB)

arebee wrote:your mpc , mr modnar , need a good seeing to.

: 0

rB)

tried that......

Mr modnaR wrote:

arebee wrote:your mpc , mr modnar , need a good seeing to.

: 0

rB)

tried that......

well there's enough holes....to keep ya goin'

arebee wrote:

Mr modnaR wrote:

arebee wrote:your mpc , mr modnar , need a good seeing to.

: 0

rB)

tried that......

well there's enough holes....to keep ya goin'

lol. had to use a hammer for the cf card slot though, ouch.

The only thing i can think of is the silence feature when chopping samples doesnt work.

when i did that, the whole system reset.

When chopping a drumloop into 64 slices.
Then saving to 64 sliced samples.
The last slice is not correct.
It sucks.

Dirk95 wrote:When chopping a drumloop into 64 slices.
Then saving to 64 sliced samples.
The last slice is not correct.
It sucks.

cosign, "a region is too short"

os 4.92

made a beat yesterday, about half of the kicks and snare are phasing. In step edit mode two events on the same time position. Double triggering phenomena i guess? time to upgrade

le rat wrote:os 4.92

made a beat yesterday, about half of the kicks and snare are phasing. In step edit mode two events on the same time position. Double triggering phenomena i guess? time to upgrade

i'd double check your event edit list first just to be sure, and re record in os492, and check again, cus i aint getting this double triggering....
or perhaps be more specific in how to reproduce it....

am just about to go 493 now anyway...

good luck
rB)

you may have copied a part of the sequence over itself. that's the only way to get 2 note values directly overtop each other.

ie

1.01.00 - pad1
1.01.00 - pad1

you can't make that happen via overdub. the 2nd just overdubs the first, rather than laying it overtop. on the other hand...

1.01.00 - pad1
1.01.01 - pad1

this CAN happen via overdub.

see which is occurring. if it's the former, the problem is that you've copied soemthing over itself.