Share your knowledge on these two classic MPCs
By miked21 Sat Jun 16, 2018 2:11 pm
Hi everybody,

I am a new MPC 60 owner and would like to clean my pad and pad sensors. I opened it up and was able to remove the cables that attach to the pad sensor but was not able to remove the white cable that spans pad sensors. Is there a trick to get this thing removed? I spent a good amount of time trying to remove it but it just wont budge -- I didn't want to damage anything.

Thanks

Mike
User avatar
By richie Sun Jun 17, 2018 5:12 am
You're not supposed to 'remove' or 'peel' the pad sensor sheet unless you want to spend money to replace it.

Clean it with contact cleaner and wipe it with a cloth.

The rubber pads themselves can be cleaned with dish soap and water.
User avatar
By JUKE 179r Sun Jun 17, 2018 10:13 am
richie wrote:You're not supposed to 'remove' or 'peel' the pad sensor sheet unless you want to spend money to replace it.

Clean it with contact cleaner and wipe it with a cloth.

The rubber pads themselves can be cleaned with dish soap and water.

This!