The place to share knowledge about upgrades, mods, customisations and all other cool DIY projects for MPCs and other music equipment.
User avatar
By richie Tue Dec 20, 2016 1:49 am
**** wrote:Got it primarily for PCB cleaning but I´ve found a lot of other uses for it too. I think every studio owner should have a bottle of it!


You're right man. The next thing I need to get is a small air compressor as I don't care to spend $4 for a can of compressed air that runs out far too fast.

For PCB cleaning, I use the 100% medical grade sh*t but if I can't find that, I'll use the 91%. Also use a non conductive brush cause I'm fancy like that. I never use rubbing alcohol as there is some type of oil in it as well and leaves residue as well.
User avatar
By loose_t Fri Dec 30, 2016 7:35 pm
Well I finally got around to trying the isoprobyl alcohol, and it does the job. A few very faint lines still there, but i was being super gentle, so maybe they will come off with a little more coaxing. Thanks for the suggestions.