By zerstorte zelle
Mon May 16, 2016 12:16 pm
Purchased an EPS Classic off of craigslist with a dead floppy drive and replaced it with an HXC SD floppy emulator. The keyboard booted and played back some sound but when sampling into the unit the unit produced little to no sound / low level fuzzing etc. couldn't monitor audio input despite it being a hot line level.
Well, popped it back open again and checked fuse. Fuse burned out and was replaced. Voltages read as the should now across the power supply. The original problem still remains however, the input into the unit shows no level and when something is sampled the resulting wavesample is extremely quiet and distorted. After recording is finished I can then ( and only then ) clearly hear the input signal... what gives? All cables reseated again.
-ZZ
Well, popped it back open again and checked fuse. Fuse burned out and was replaced. Voltages read as the should now across the power supply. The original problem still remains however, the input into the unit shows no level and when something is sampled the resulting wavesample is extremely quiet and distorted. After recording is finished I can then ( and only then ) clearly hear the input signal... what gives? All cables reseated again.
-ZZ