Forum for all other samplers & synths such as Maschine, MVs, Akai S & Z series, Roland, Korg, OP-1, analog synths etc.
Posts: 43
Joined: Tue Nov 5th, 2013
Have you tried removing your RAM and cleaning the contacts?
Advanced Member
Posts: 1882
Joined: Sun Jun 26th, 2011
Location: Mars
By
jambo
Wed Jun 15, 2016 6:47 pm
nope. RAM test says its ok. monitor signal is ok too.
samples are not immediately distorted. they became that after 20 / 30 minutes of working
Posts: 43
Joined: Tue Nov 5th, 2013
/viewtopic.php?f=42&t=172786Robbinson wrote:Fixed it!!! It was a loose IB05 connection - It's located on the top right board. There were a couple loose connections. Even as they seemed to be in contact there was a little play in one of them. Snapped it back into play and click.
... ...
If you ever have this problem ... yes - Check the connections and give them a nice plug. They look as if there can be no loose connection but push them in and be extremely careful. Especially in the small port places like in between the input on the front. Once the unit is opened there is tons of circuitry - those little places that your fingers can't reach. I used a stylus but you can use a pencil eraser. But be finesse with the pressure ... there are a lot of small diodes and soldered chips that bend if you get in their way. Watch out for those. I'll post some pictures tonight.
Advanced Member
Posts: 1882
Joined: Sun Jun 26th, 2011
Location: Mars
