By Wes Clarke
Fri Oct 06, 2017 3:23 pm
When I record automation with the q links for parameters like tuning for example...
Initially when I record it I can clearly see the automation and that area has blue lines in the software.
I have noticed that when I close the project and open it again (in the software), the automation is played back, however, it doesn't list what that particular automation info is.
It just says "Modifier" and you will see a couple of red dots in the editor and no mention of what that "Modifier" is.
Not sure if I am the only one having this issue with automation?
Initially when I record it I can clearly see the automation and that area has blue lines in the software.
I have noticed that when I close the project and open it again (in the software), the automation is played back, however, it doesn't list what that particular automation info is.
It just says "Modifier" and you will see a couple of red dots in the editor and no mention of what that "Modifier" is.
Not sure if I am the only one having this issue with automation?