By GotHemi
Mon Jan 23, 2017 11:22 pm
I've started thinking about the outs of hardware synths that have stereo outs... if you could just monitor & record them in mono, then apply "stereo" FX in the DAW, set up on sends.
But sounds like the Supersaw, coming from the original JP-8080... would you run it out stereo or mono?
Then, for big spacial pads that are wide... would you run them in stereo or mono, then apply chorus/delay/reverb in the DAW?
Running stuff in mono would save lots of inputs on the interface, if it would make sense to run in mono.
But sounds like the Supersaw, coming from the original JP-8080... would you run it out stereo or mono?
Then, for big spacial pads that are wide... would you run them in stereo or mono, then apply chorus/delay/reverb in the DAW?
Running stuff in mono would save lots of inputs on the interface, if it would make sense to run in mono.