Forum for all other samplers & synths such as Maschine, MVs, Akai S & Z series, Roland, Korg, OP-1, analog synths etc.
By [email protected] Tue Jan 10, 2017 1:46 pm
ENSONIQ EPS 16+ RACK MOUNT
problem : sampler was left on over night, and froze up.
after restarting the sample input is on full with no signal input to sample in
now when I sample the "full sample level" ie sample input shows >IIIIIIIIIIIIIIIIIIIIIII
and when sampled nothing is played back
when trying to sample with a source meter is on >IIIIIIIIIIIIIIIIIIIIIIIII
once again no sound plays
Any EPS family had this happen and/or know a solution?
User avatar
By Wal Martian Tue Jan 10, 2017 4:25 pm
Leaving it on overnight could have generated heat and expanded the circuit board causing a dry joint. First thing I would do is open it up and check the solder points.
Last edited by Wal Martian on Wed Jan 11, 2017 5:53 am, edited 1 time in total.