By Jay Brown
Wed Jan 13, 2016 5:04 pm
So my 950 has been working fine the past few months...and the other day I booted it up after some time away for the holidays and such. Now whenever I format a new disk it goes through the process of doing so but does not allow me to load/save or write anything on to the disk stating the error that the disk has not been formatted. Page 9 under Disk reads new floppy has 0% memory used up but on every other page under Vol it reads UNFM meaning unformatted...I am and have been using just a few Fujifilm MF2HD floppy disks which are 1.44 MB. Just ordered a floppy disk cleaner kit to utilize on the disk drive....will read in to that as well to make sure thats okay to do and doesnt ruin the drive in anyway.
i have Max Ram on this machine and am running 1.2 on my machine which leads me to my next point/question. I ran into a cf card reader that you can install in to the S950 and was curious if anyone has seen or had an experience with said machine. http://www.artmix.com/wordpress/?p=433
http://www.ebay.com/itm/Stratos-Technol ... XQWzNSpFs4
I am currently using a MPC 2500 as well which has a cf reader so it would be a thing of beauty to be able to install this bad boy if I had to replace the floppy disk drive. I run all mac based hardware and would like to avoid HxC emulators.
Thanks ahead of time![/b][/b]
i have Max Ram on this machine and am running 1.2 on my machine which leads me to my next point/question. I ran into a cf card reader that you can install in to the S950 and was curious if anyone has seen or had an experience with said machine. http://www.artmix.com/wordpress/?p=433
http://www.ebay.com/itm/Stratos-Technol ... XQWzNSpFs4
I am currently using a MPC 2500 as well which has a cf reader so it would be a thing of beauty to be able to install this bad boy if I had to replace the floppy disk drive. I run all mac based hardware and would like to avoid HxC emulators.
Thanks ahead of time![/b][/b]