Forum to discuss all matters relating to the MPC1000 and MPC2500 operating systems created by 'JJ' (all versions).
By DuckBilledPad-a-Push Sun Jan 08, 2017 7:07 pm
More Specifically, I can record new samples. Find them in the trim menu. However, when I go to program menu and scroll through available samples to assign to pad, the list stops short of showing all the samples I can access in the trim menu. I have looked in the manual and cannot find anything that addresses this directly, at least not in any indexed fashion. Hopefully this question isn't forehead slapingly dumb; any advice is appreciated.