hi... really hope someone could help me out with this cos its causing me no end of grief. Im using an mpc2000. im loading up a programme and sequences... and a couple of song modes. when i go into my 2nd song (just the same tune on my first song with a different arrange ment), when i reach say step 44, bar 66 it all goes blank. all the sounds seem to dissapear off the pads. what is actuallly happening though ( i think) is it seems to be defaulting to a new programme, where there are no sounds. when i press shift and programme and go through the progarmmes that are loaded there is a blank one that always comes up, it says 'new programme'. so basically it defaults to this, i want to stop it doing this.
any help appreciated.
any help appreciated.