SAVING PITCH/TUNING OF A SAMPLE!???

Ok i gotta question...i made a nice piano loop with some piano Hit samples i had..anyway the piano only sounds good when the picth is lowered and tuned to -120. So anyway my question is how can i save this? Because everytime i load the .ALL and .APS files everything is intact EXCEPT the pitch/tuning...so i gotta fo to trim mode and manually set it over and over again...is there any way around this???like a quick way i can just save the picth/tuning settings??

Instead of adjusting the pitch from the trim screen param's, go to your program screen and adjust the pitch there (upper right of the pgm screen).

That way the change is saved, when you save your program.

why dont you just record the pitch value into the tracks sequence using the NV slida. then you wont have to change the samples original settings it will just be lower for that particular sequence.

nanoloop wrote:why dont you just record the pitch value into the tracks sequence using the NV slida. then you wont have to change the samples original settings it will just be lower for that particular sequence.

Because in some cases it's easier that way.

Re-save the sound that you changed the pitch on.

If you change the pitch in the trim screen, you have to re-save that sound individually. If you change the pitch in the program screen, re-save the program.

You can also save the program, and in the save screen set "replace same sounds to YES." That will take care of both at once, but it will resave all the sounds.

GOOD LOOKIN OUT FOR THA TIPS FELLAS!!!

WHEN SAVING!!!!!


REPLACE WITH SAME SOUNDS YES!