Trying to load internal ZIP, but SCSI always comes up

In the past few days, whenever I use the "load" function, it goes automatically to looking for a SCSI device, even though there is not a SCSI device hooked up (nor has there ever been). When I used to hit "load", it would automatically go to my internal ZIP drive, which is where I'd prefer it to go when I use this function. Any tips? Thank you for your time.

You must have changed the primary device setting.
Go to the LOAD page and press SET UP.
Change the PD to ATAPI.

THANX TO *PILCHARD* I HAD THE SAME PROBLEMS ITS FIXED THANX AGAIN!!!!!!!!

*Pilchard* wrote:You must have changed the primary device setting.
Go to the LOAD page and press SET UP.
Change the PD to ATAPI.

THANX MAN I HAD THE SAME PROBLEM!!!!

No worries, glad you got it sorted BM.