By ZeHa
Tue Jan 24, 2012 1:00 pm
Hey there,
forgive me if this has been asked before, but I wasn't able to find anything about this issue.
Until now, I have been working with my MPC2000XL just fine, but recently I tried to load some samples and they were not mapped into the program as "one shots", instead they are loaded as a "loop" which plays as long as a pad is held down. I also noticed that the poly mode is set to "Note Off" and I cannot change it to Mono or Poly.
Why is that? It's only with some specific samples. They are all plain WAV format and are simple drum samples from the krb6 library or whatever it's called. I also noticed that those that made problems were stereo samples, but I already had different stereo samples in the past which were loaded correctly.
forgive me if this has been asked before, but I wasn't able to find anything about this issue.
Until now, I have been working with my MPC2000XL just fine, but recently I tried to load some samples and they were not mapped into the program as "one shots", instead they are loaded as a "loop" which plays as long as a pad is held down. I also noticed that the poly mode is set to "Note Off" and I cannot change it to Mono or Poly.
Why is that? It's only with some specific samples. They are all plain WAV format and are simple drum samples from the krb6 library or whatever it's called. I also noticed that those that made problems were stereo samples, but I already had different stereo samples in the past which were loaded correctly.
