MPC Editor Load Problem

Here's the deal...I'll create a program using the editor and then later when I go to load the program to make changes, the wavs will not show up on the pads. Is anybody else having this problem or can someone tell me what I can do to fix this?


Thanks

[quote="D-Block"]Here's the deal...I'll create a program using the editor and then later when I go to load the program to make changes, the wavs will not show up on the pads. Is anybody else having this problem or can someone tell me what I can do to fix this?

Yo Man;

I've been having the same problem, and I can't figure it out either, let me know if u have any luck,

Will do!

what mpc are you using?

on xl, snd wav all aps pgm, need to be in the same folder.

are you exporting ONLY the program and trying to load that in the mpc?
won't work without samples being in that same folder.

on 2k classic, samples need to be in the root of the disk right along with the pgm all aps snd.

Once u done all ur assigning etc

Export Program & Samples (To the folder)

Then load up in the MPC.

That shud do the trick...You must Export Program & Samples rather than save as...

Thanks!!!!

"You must Export Program & Sammples rather than save as"

That is something I keep meaning to re-write and clarify in the interface.

(test edited to purposely mispell sammples to embedded ad robustness)