Installed card reader and screen went funny ?

Technical questions for the MPC2000xl and the MPC2000
 Reply Share on Facebook
User avatar

By maxlifo Fri Jul 28, 2006 10:29 am
Sounds obvious but open it up again and make sure the cables to the screen are OK...
User avatar

By yepz Fri Jul 28, 2006 10:33 am
Im sure its not the case cause while the case was off and i noticed the screen proplem i then reconnected the ZIP 100 drive to insure its not loose plugs and the proplem was gone.
User avatar

By pt3r Fri Jul 28, 2006 12:21 pm
Why did you buy this card reader? As far as the specs go it's not very usable in an MPC since it does not support hotswap unless connected to some specific IDE interfaces.

EDIT: Make sure your cardreader is IISDMC compatible.

By The Associate Fri Jul 28, 2006 2:23 pm
I have the addonics card reader and it's rad. Top quality.

The Associate
___________________________________________________________
MPC 2000XL, Dave Smith Evolver, Juno 106, Mackie 1202
 Reply
Return to MPC2000xl, MPC2000