By
Lampdog
Thu Jun 28, 2007 7:24 pm
I've been inside both machines, 2k/2kxl, they use the same type of ram, 16x2 or 1x32 can be used.
Installing Memory Expansion
The MPC2000XL’s internal memory can be expanded to 32Mbytes using SIMMs. The
MPC2000XL comes with 2Meg of memory ‘hardwired’ and there are two slots in which you can
install SIMMs chips. The SIMMs board is inserted at a slight angle and then pushed back where it
clips into place. Some SIMMs boards have the memory chips mounted on both sides sometimes.
However, the boards can only be inserted one way so you shouldn’t have any problems. Be
careful not to force them into place otherwise they may snap.
SIMMs operate at different speeds. SIMMs that operate at a speed of 70nS (nanoseconds) or
faster are recommended.
SIMMs also come in various sizes. Please note the following memory configurations that are
possible in the MPC2000XL.
* When 32M SIMMs are installed, the 2Meg on the MAIN board is ignored.
Note: Memory chips are sensitive to static electricity. Please observe the following
safety precautions:
• Unplug the MPC2000XL before installing the board(s).
• The SIMMs may come with a special wrist strap to discharge static electricity.
We suggest you attach the strap to the MPC2000XL’s case. If a wrist strap or
any other such accessory is not supplied, try discharging any static by touching
an earthed metal object before handling the boards.
• Always handle the memory board by its edges - avoid touching the components
on the board.
• To minimise static electricity, avoid carpeted areas and low humidity areas.
Stop getting automatically offended when you see gold letters!
