Technical questions for the MPC2000xl and the MPC2000
By louis futon Sat May 09, 2009 3:16 pm
sometimes my pads are cracking when i play out my sounds.

it can´t be some bad trimming because after i recorded the sounds there is no cracking at all.

could someone clear this up for me?

thank you!
By louis futon Sat May 09, 2009 5:35 pm
Fung45 wrote:Define cracking. You mean after you sequence? Could be an air bubble under your pad sensor. You might have to open it up peel it off and re glue it or get a new one.



it cracks when i hit the pad multiple times. especially if i hit them fast.

i´ll check the pad sensor! are those air bubbles visible?
User avatar
By jazzbee Sun May 10, 2009 10:36 am
the cosmic pimp wrote:AIR BUBBLES ARE LIKE SPUNK BUBBLES................!!!!!!!!!!!!!!!!

:roll:

WTF are you on m8?
User avatar
By Fung45 Mon May 11, 2009 1:29 am
Air bubbles are def. visible just take off your main case and lift up the rubber pads. You probably have one big bubble under the pad or pads that are cracking. Try peeling up the sensor sheet and spraying some 3M spray glue (not the foaming kind) where the bubble is and smushing it back down. If that don't work you may need a new one.