'Tic' noise at the end of my loop

Hey,

I'm new with the MPC 2000XL. After a couple of days and a lot of coffee I think I understand every possibility of the machine, but I have a problem that I can't fix.
I'm looping a 1 bar flute loop in the TRIM mode, and each time the loop starts over I get a 'tic' sound.
And it's not noise on the sample, because it doesn't show on the graphic display of the sample.
What is it and what can I do to get rid of it?
Tnx a lot!

its the sample. You need to trim it precisely and it will go away.

play with the release setting, makes it often smoother.attack could do the job also....

poundaproblem wrote:its the sample. You need to trim it precisely and it will go away.

Werd...you either go an extra bit at the tail end or right at begining........

be sure to trim when the wave forms cross thru @ zero dB

dcook79 wrote:

be sure to trim when the wave forms cross thru @ zero dB

+1 Use the Zoom control to trim the the exact spot.

too shay

alright, tnx for the answer!!

Truncate in the param field DECAY 19% ,try when your TRIMIMNG your sample to make them end with an 0 5 owrks for me.
if that dont work then use the silent section in your edit field. and highlight aera and silent section