By BGBEATS
Fri Jun 11, 2010 9:53 pm
if you got your 2kxl turned on and you power off then back on real quick you might blow the fuse
if you blow the fuse (basically your 2kxl seems completely dead)
unplug the power cord flip over take the bottom metal panel off you will see your blown fuse sitting there near where the power switch pushes in.. replace it with new fuse put the panel back on and power up.
I did it today so figured would add here in case anybody else has it happen .
I blew the fuse the above way, yet it could happen other ways too
home depot for like 3 bucks for a couple of em
5mm x 20mm 250 volts to 3 amps
125 volts to 5 and 6 amps
BP/GMA-2A
if you blow the fuse (basically your 2kxl seems completely dead)
unplug the power cord flip over take the bottom metal panel off you will see your blown fuse sitting there near where the power switch pushes in.. replace it with new fuse put the panel back on and power up.
I did it today so figured would add here in case anybody else has it happen .
I blew the fuse the above way, yet it could happen other ways too
home depot for like 3 bucks for a couple of em
5mm x 20mm 250 volts to 3 amps
125 volts to 5 and 6 amps
BP/GMA-2A



