Trim screen bug?

Model is a 2xl mcd.
o.s. 1.2

Problem

While in the trim screen with the "end" value highlighted, if press the "shift" button to change the place value highlighted the "end" value starts jumping around closer to the "start" value. This only happens by just pressing the "shift" button, nothing else, no jog wheel movements, no arrow keys. All other functions respond as they should in other screens. I pulled a search and found no mention of anything relating to this. Anyone dealt with this or aware of what the problem is?

No man that's a bizarre one. I just fired up my XL MCD with 1.20 and could not repeat the described behavior at all. Everything was dead normal.

Hope a clue is found or posted soon man. But not being able to repeat the wonky behavior is all I can offer.

hmmm.. and this doesn't happen on the start point too? is it possible the note variation slider is jittering?

Metatron72 wrote:No man that's a bizarre one. I just fired up my XL MCD with 1.20 and could not repeat the described behavior at all. Everything was dead normal.

Hope a clue is found or posted soon man. But not being able to repeat the wonky behavior is all I can offer.

Same here.

I've encountered the same issue. *Before

Trying to duplicate it now without success.