By Wreckon1
Mon Apr 24, 2017 9:12 pm
Hey guys,
I've been searching the forums but haven't seen anybody with this issue. I've got 3 top PCB control boards, and none of them work! I have a good board and it works fine on my unit, but when I plug in and test the other 3, there is no response from any of the buttons, data encoder or pads. When I first turn the unit on, all the LED's light up, so I know they're getting power. They just don't respond at all. I'm wondering if anybody has experienced this, and if so, is there a common resistor or something that gets blown that might be the cause. Any help or suggestions would be great. Thanks all...
I've been searching the forums but haven't seen anybody with this issue. I've got 3 top PCB control boards, and none of them work! I have a good board and it works fine on my unit, but when I plug in and test the other 3, there is no response from any of the buttons, data encoder or pads. When I first turn the unit on, all the LED's light up, so I know they're getting power. They just don't respond at all. I'm wondering if anybody has experienced this, and if so, is there a common resistor or something that gets blown that might be the cause. Any help or suggestions would be great. Thanks all...