I have a question for one of you who've already fixed your slider. Before I even start bending parts, are the little contacts supposed to be flat or pointed upward (like the picture below)?
This picture is from the slider in my 2000xl (broken nv slider). I was thinking about taking apart my other unit to see if it's sliders are flat or "upright", but if I can keep from going into it too...
So, flat or upright? I can see the bent parts, so that's to be fixed either way. I just need to know if you all are straightening yours to an angle, flat against the base it's attached to, or pointing up (as in my photo). For those who don't follow, I'm taking about the little contact prongs. Thanks for any help.