drum disk (quick question)

when i load a drum disk with drum sounds/programs and put in a new disk to make a beat/sequence/and add samples with the drum sounds from the drum disk. Is there a way to save the beat with just the drum sounds i used, instead of saving the whole program (from the original drum disk) and taking up disk space.

if this makes any sense please respond

any response is GREATLY APPRECIATED

THANK YOU

Yes, you just need to remove the sounds you are not using from the pads they are assigned to in the original program, then save that new program which has fewer drums. Make sure you rename it if you are saving to the same disk as the original drum program or it will overwrite it.

after i do what u suggested....so i dont need to load the original drum disk everytime i want to load the beat i made it with, right? how do i remove the unwanted sounds that i didnt use?.......do i go to "program" and go to each individual sound i didn't use put them as "sound OFF"?

thanks as always

..do i go to "program" and go to each individual sound i didn't use put them as "sound OFF"?

Yes......