By enchilada
Wed Jun 08, 2022 5:22 am
Hi all
I did a little searching but couldn't find an answer. I have a SCSI2SD V5.5 which I believe should draw power from the DB25 SCSI port of my MPC2000 Classic. If I plug it in with the USB cable plugged in then it works perfectly, but if try without then it doesn't recognize the drive.
With USB I can also see a little LED flashing when I access the drive but there is definitely no LED activity without the USB cable.
Has anyone else successfully used SCSI2SD V5.5 without a USB cable? I'm assuming it's not the SCSI fuse because I would have thought that would knock out the drive altogether.
Any help is appreciated
I did a little searching but couldn't find an answer. I have a SCSI2SD V5.5 which I believe should draw power from the DB25 SCSI port of my MPC2000 Classic. If I plug it in with the USB cable plugged in then it works perfectly, but if try without then it doesn't recognize the drive.
With USB I can also see a little LED flashing when I access the drive but there is definitely no LED activity without the USB cable.
Has anyone else successfully used SCSI2SD V5.5 without a USB cable? I'm assuming it's not the SCSI fuse because I would have thought that would knock out the drive altogether.
Any help is appreciated
Kris
My gear:
MPC 60MKII/2000/2000XL/2500/X, s900, EPS 16+, ASR-X, S2400, Digitakt, SP202, Liven LoFi12, Mikrofreak and a small modular setup
My gear:
MPC 60MKII/2000/2000XL/2500/X, s900, EPS 16+, ASR-X, S2400, Digitakt, SP202, Liven LoFi12, Mikrofreak and a small modular setup