By Ogoki
Wed Jan 18, 2023 7:50 pm
Hello all,
First post here. I picked up an MPC2000XL a while back and I am finally getting around to trying to use the 8 outs. It turns out that the output from all 8 outputs is very weak and distorted.
The two fuses on the output board are good, but the voltage at one of them is 11V rather than 5V, so I assume this is the problem. I was hoping the problem was just the regular, as I read that they tend to go, so I replaced it (7805A) to no avail.
Can anybody recommended what I should check next, before taking this thing to a tech, or just sticking with the main outs?
Thanks.
First post here. I picked up an MPC2000XL a while back and I am finally getting around to trying to use the 8 outs. It turns out that the output from all 8 outputs is very weak and distorted.
The two fuses on the output board are good, but the voltage at one of them is 11V rather than 5V, so I assume this is the problem. I was hoping the problem was just the regular, as I read that they tend to go, so I replaced it (7805A) to no avail.
Can anybody recommended what I should check next, before taking this thing to a tech, or just sticking with the main outs?
Thanks.