Is my MPC2000XL missing parts?

Technical questions for the MPC2000xl and the MPC2000
 Reply Share on Facebook

By spectre Wed Mar 02, 2005 5:05 am
Can't see the picture but the slots are probably for the memory.

By Usted Wed Mar 02, 2005 5:18 am
I'm having problems posting pictures. When you open up the panel from the bottom and hold it upside down , it's a blacl bezel kinda like a processor holder on a computer and just to the left is a blue bezel for an electronic chip. I already used up the slots for the memory.

By Usted Wed Mar 02, 2005 5:29 am
The link works now. I drew yellow arrows to the 2 empty bezels. Thanks

By Usted Wed Mar 02, 2005 6:13 am
bump, ne one? Link works thx

By elmacaco Wed Mar 02, 2005 6:34 am
one might be flash memory option, not sure what the effect card looks like, does it work? If so, don't worry.

I got a laugh from the pic title, MPC GUTS!!!

By Usted Wed Mar 02, 2005 7:09 am
The blue bezel says "boot rom"?? underneath on the circuit board. But the black bezel in the right corner? Yeah, it works so far but I wanted to address any issues with the seller before long. And the MPC boots as soon as I power it on. Thanks again.
User avatar

By enotide Wed Mar 02, 2005 12:19 pm
Check the Manual, in the back there will be a diagram of what goes where.
This should maybe help you out.

By lo-fi Wed Mar 02, 2005 12:28 pm
There should be empty slots on the board for flash rom and for the SMPTE chip. If the MPC boots up, don't worry about the empty slots.

By Usted Wed Mar 02, 2005 11:48 pm
thx all, one says "select boot rom" below the blue one and the other I have no idea. It boots up and the memory is being read properly so THX ALL.

By mpc3000 Thu Mar 03, 2005 4:29 am
That slot is for a service part (used by repair centers only).
User avatar

By JUKE 179r Thu Mar 03, 2005 8:45 am
OH MY GAWD!!!! :shock: You are missing the mass conducer piece for the flux capacitor!!!
Try e-bay...

By mpc3000 Thu Mar 03, 2005 1:23 pm
"You are missing the mass conducer piece for the flux capacitor!!! "

You know that that likely the part that gives the MPC3000/60 that special swing (according to MPC3000/60 owners). Akai Pro just left it out of the MPC2k series.
User avatar

By pt3r Thu Mar 03, 2005 1:47 pm
mpc3000 wrote:"You are missing the mass conducer piece for the flux capacitor!!! "

You know that that likely the part that gives the MPC3000/60 that special swing (according to MPC3000/60 owners). Akai Pro just left it out of the MPC2k series.


I have looked on ebay but there are none for sale do you think the IDE version will work in my mpc 2000 xl ?

By Usted Thu Mar 03, 2005 5:20 pm
3000 try, search: 1 MPC2000xl soul -cd -floppy -set
 Reply
Return to MPC2000xl, MPC2000