8 outs help needed

installed my 8 output board and now when i try to load a beat it says not enough memory. i was able to fix this last night (no idea how just toyed with the simms alittle) and it started to work fine.

i had a hum when i tried to sample so i tried to figure out what was the problem since it started after i installed the 8 outs. when i tried to figure it out i ended up with the memory issue again but this time i can't get it working again.

any of u had this problem or can help out with what could be wrong? thnx.

Someone just posted this same problem a few threads down.You should check the simms one at a time to find the bad "seed" and once you've done that just replace it with a new one.You should be o.k. after that.


2.

after the first time i had the more memory needed problem and fixed it i had 32mb of sampling still so i'm not sure what the deal is. since both are in then at least 1 should be enough memory. i couldn't even get a sample loaded. i think i moved something in there but i tried taking the simms in and out a few times with no luck at fixing it a second time.

also getting alot of noise when i put it in sample mode hope i didn't blow my mpc up. any help would be well appreciated.