Oh snap!

Went to work on a track in the mp, and it is really acting fragged up. For some reason, it is playing sounds without me touching a pad. It does this for about 10 seconds then stops, then starts up again seconds later.
I haven't loaded any programs/seq, just 2 sounds onto 2 pads.
I've powered down, and reloaded the samples and it does the same thing. I've even reloaded the OS, and still the same thing. Any ideas what the hell is going on?

dust on the sensor sheet under the pads?

just delete all tracks and sequences after u load up the sounds

Well, I opened it up, used a air can to clean it, and it's working fine now.
I hope that dust was the only problem!