jumper settings?????internal card reader

Technical questions for the MPC2000xl and the MPC2000
 Reply Share on Facebook
User avatar

jumper settings?????internal card reader

By Errupt Mon Jan 08, 2007 10:50 pm
Does anyone know what jumper setting I would use for installing an internal card reader?
I'm swapping out my floppy drive to the cf card reader and before I actually start I wanted to figure this out.
I got the drive from synchrotech, like many of you, and the directions give 3 different settings
Master, Slave, or master & slave.
I think it would be either slave or master and slave but anyone who knows could you PLEASE help me out.
User avatar

By Lampdog Tue Jan 09, 2007 12:43 am
There is only 1 drive on that data ribbon, so it isn't a slave to any other drive on the same ribbon.

It's not a secondary drive on the ribbon either, it's only 1 drive present correct?

It only takes a few seconds to figure out the rest, by connecting the jumper and turning on the power, trying a different jumper and turning on the power again.
User avatar

By Errupt Tue Jan 09, 2007 12:55 am
I found the answere on midicase.com
it needs to be the master jumper setting.
Thanks Lampdog

The guys at the computer store could only find a dual drive data cable and told me it would work for a straight connection from the card reader to the motherboard of the mpc.
Is it gonna work?

By The Associate Tue Jan 09, 2007 4:19 am
You can cut what you don't need off with scissors if you want it to be neat.


The Associate
_____________________________________________________________
MPC 2000XL, Dave Smith Evolver, Juno 106, Mackie 1202 VLZ.
 Reply
Return to MPC2000xl, MPC2000