Hello everyone,
Just wandering if anyone could help a lost soul!
I have my mpc 2000 connected to an akai s3000 sampler which triggers notes on the s3000 via midi. I have it set up that when my mpc changes sequence(song) it changes the program in the mpc when i hit play and then i manually change the program in the s3000 so that it triggers the right sounds there.
However, on two important occasions when i have pressed play on my mpc it has flipped the program in my s3000 and if i change it to the program i want, when i press play it just flips it to the wrong one again. 99% of the time it doesn't do this. After a re-boot of both modules it doesn't do this.
Why is it doing this? Have i set them up wrong? Any help or advice would be appreciated.
Just wandering if anyone could help a lost soul!
I have my mpc 2000 connected to an akai s3000 sampler which triggers notes on the s3000 via midi. I have it set up that when my mpc changes sequence(song) it changes the program in the mpc when i hit play and then i manually change the program in the s3000 so that it triggers the right sounds there.
However, on two important occasions when i have pressed play on my mpc it has flipped the program in my s3000 and if i change it to the program i want, when i press play it just flips it to the wrong one again. 99% of the time it doesn't do this. After a re-boot of both modules it doesn't do this.
Why is it doing this? Have i set them up wrong? Any help or advice would be appreciated.