pads broken & stereo outs and ins broken

hello i just open my mpc an remove the pad sensor then i reconect..... and when i turn on my mpc they **** dont work an the outs an in dont work...... you can help me or i have to send to vst sereice to fix that???

You probably haven't connected the pad sensor correctly back on the mobo. Check the ribbon safety clip. Also, check the cables on the I/O board. You have probably disconnected something which was already loose.

If your MP is loading nice, you probably haven't done anything fatal to it so check again all the connections. Usual mishap with the DIY route.

you 16 velocity pad strip has to be inserted into the middle slot of that small Black Rectangular clip ..... NOT UNDER.......

its kinda difficult to move that thin strip..... But its just a user error....


That black rectangle clip is not meant to come off though... just slide it out....... Push the sensor strip in between and close the black clip......
turn it on and go to your program screne to assign soundsto the pads... and they should read/////

go get it serviced. don't hesitate

nanoloop wrote:go get it serviced. don't hesitate

WORD