Lampdog wrote:matti-san wrote:the only reason i can think someone would prefer the main outs over the 8 individual outputs is that if they have the eb16 effects board and want to track with the internal effects applied... the 8 individual outs are dry signal only.
Page 139 2kxl manual says different, I've also done it so I know it works
Chapter 9: Effects, Page 139, Multi-effects
The MPC2000XL has two multi-effects and each has five effect modules. You can execute various
routings by rearranging the modules. Select MULTI FX1 or FX2 in the Edit: field of
the FXedit screen and then select MIX with the CURSOR keys.
Press OPEN WINDOW to open the Effect Mixer window.
Direct sig: This turns the direct sound of the signal input to an effect on or off. When it is
ON, the level or pan of the direct sound is adjusted by the stereo mixer.
Patch: To set the effect routing.
Output: To select the output of the effect (left and right or individual outputs 1/2, 3/4, 5/6, 7/8).
Dist/EQ: This sets the output level and pan of the distortion and filter modules.
Mod/Echo: This sets the output level and pan of the modulation and delay/echo modules.
Wid adjusts the stereo range of the effect. When Wid is set to 0, the output effect sound
becomes monaural.
Reverb: This sets the output level and pan of the reverb module.
Do you know how to send individual sounds including internal effects to a single output?
With your instructions from the user manual on page 139, the individual output receives the signal of the entire song and not of the individual sound?
Even though I assigned the sound to the individual output in the individual out screen of the mixer?