MPD32 - Need Help Bad!!!

Hey guys, long time lurker, 1st time poster!

I recently tried to upgrade the pads in the mpd32 and it all appeared to go OK but when I reassembled it the LCD would not light up. I noticed that the LCD PCB has 2 wires attached to it that connect (via screws) to the main PCB and secondary PCB.
I know where one of the wires attched (to the secondary PCB) but do not know where to attach the other wire.

Does anyone know where it attaches? Or does someone have a photo of any MPD32 with the back taken off so I can see it myself?

I've searched everywhere but can't find any info on it.

Any help is much appreciated...

Thanks in advance..

Don't hold your breath...

just opened mine up a few weeks back, but i didn't take shots. the 2 grounds had a different pcb pad though with silver screws.

also make sure you didn't catch he ribbon in the case when you re assembled.

i have to crack my buddy's open whenever his new pads get there (next few days). i'll post here when i do.