reason mpc sync issues

ok i know reason only acts as a slave so it only recieves midi clock signals...
i am running a mac os9.1 using OMS & an emagic MT4 midi device, i ran a midi cable from the MPC out to the in of the mT4, seems im gettin midi recieved messages in OMS, however, reason will not recognise the mpc when i click midi sync, i also have the settings in the reason prefs correct, am i missing somthing, im losin my mind?

thnx

soulrez

24 views not one bit a help... argghhh, cant even get a reply on the akai forum...

I guess no one else is masoshistic enough to run reason on a Mac with an MPC

I have a Mac running Reason, Pro Tools, MPc 4000 and a few modules...

You everything in the MAC was set correctly now did you sync the internal sync page on the MPC???

If you are using a 2000xl or lower there is a screen you have to go into to turn on the Midi beat clock sync...Just set the page so that the Sync Comes in and out the same channel..And usually midi does not like

0 for some reason two machines never link up completey at zero.....

So start your sequence always ahead in the Midi beat clock..
Like on sync in the MPc set the time to 23.00.00.00
That way your sequence is 23 hours ahead, but still on the 1st bar..

I have a Mac running Reason, Pro Tools, MPc 4000 and a few modules...

You everything in the MAC was set correctly now did you sync the internal sync page on the MPC???

If you are using a 2000xl or lower there is a screen you have to go into to turn on the Midi beat clock sync...Just set the page so that the Sync Comes in and out the same channel..And usually midi does not like

0 for some reason two machines never link up completey at zero.....

So start your sequence always ahead in the Midi beat clock..
Like on sync in the MPc set the time to 23.00.00.00
That way your sequence is 23 hours ahead, but still on the 1st bar..