For discussion about setting up your studio and advice on the gear and equipment within it.
User avatar
By cybernaga595 Sun Mar 16, 2003 7:24 pm
I've been researching and am a bit puzzled. Pardon my ignorance but i thought the only way to sample onto my 2000xl was through a dj mixer? Searching on the forum some of you guys meniton pre-amps as an alternative to a dj mixer. My question is do they produce the same sound quality?

Wouldn't i still need to purchase a "power amp" as they say on the website? http://www.creekaudio.co.uk/products/p43.asp#

If regular pre-amp's give better sound quality why do most people use dj mixers when they sample from turntable? Can someone clears this up? Thanx for all replies, peace.

By elmacaco Sun Mar 16, 2003 7:43 pm
cuz they alreay have a dj mixer?

shit I don't know, I have a small preamp box for my table and it works great. the only dj mixer I ever used was kinda cheap and alot noiseier than the preamp.

YMMV
User avatar
By cybernaga595 Sun Mar 16, 2003 8:22 pm
After researching some more i still see no diff. Here i am planning on getting some expensive azz dj mixer when i can get the same functionality out of a regular pre-amp, go figure. It sux when u dont have a good knowledge of certain things. ohh well, thanx yall.
User avatar

By MPC-Tutor Sun Mar 16, 2003 8:50 pm
If you are not a DJ, go for the Preamp for quality.
User avatar
By cybernaga595 Mon Mar 17, 2003 5:44 am
im going pre-amp for sure. So heres the problem: I wanna be able to run my turntable into a preamp, from a preamp into a monitor/speaker (so that i could hear the record as there no headphones accesiblity on a preamp), and also from the preamp i want to go to my 1/4" jacks in my 2000xl (so that i can sample).

The only problem is im not sure the specifications i'm going to need when looking for this preamp. Is this using 2 or 3 channels [im really not accustomed to those terms]? Do such preamps even exist? Thanx to any1 who replies...
User avatar

By MPC-Tutor Mon Mar 17, 2003 7:47 am
It's usual to hook up this way instead

TURNTABLE, PREAMP, MPC INs, MPC OUTs, (optional mixer), AMP + SPEAKERS

So basically, it's your MPC that is connected to the amp, and you can only hear the turntable when the MPC is set to sample.

Any amp will do - hifi amp, power amp etc - no need to get some really expensive one if it's only for home use at normal volume levels.
User avatar

By cybernaga595 Mon Mar 17, 2003 8:36 am
thanx for dropping tha knowledge tutor! whats the difference in the channels though?