By turnipwagon
Wed Nov 10, 2021 4:39 pm
Hello All,
I'm new to the MPC and the forum and wonder if you can help?
I have an MPC One and I am trying to set it up with the ADAT XT multitrack via MIDI (MTC and MMC). I am struggling to set the MPC One as a slave so that it is locked to and triggered by the ADAT. I have the MPC One set to receive MTC and MMC but it doens't seem to receive any info and I can't see how to set it as a slave. I can kind of manage it the other way round where the ADAT is the slave and the MPC One is the master with the MPC One midi output port set to Sync, so I think the right connections with cables etc are in place.
Any ideas how I need to set the MPC One as a Slave to the ADAT XT Multitrack?
This is the gear I'm using:
MPC > MOTU Midi timepiece II (MIDI patchbay) > JL Cooper Data Master > ADAT XT
Many thanks in advance!
I also have the ADAT XT linked via optical cable to the Yamaha 03D mixer - I often get a YGDAI input SYNC Error with lots of popping from the mixer despite the mixer and ADAT both being set to 48Khz. Any ideas about how to fix this? Do i need some other Word Clock equipment. The mixer and ADAT are only connected via optical cables.
I'm new to the MPC and the forum and wonder if you can help?
I have an MPC One and I am trying to set it up with the ADAT XT multitrack via MIDI (MTC and MMC). I am struggling to set the MPC One as a slave so that it is locked to and triggered by the ADAT. I have the MPC One set to receive MTC and MMC but it doens't seem to receive any info and I can't see how to set it as a slave. I can kind of manage it the other way round where the ADAT is the slave and the MPC One is the master with the MPC One midi output port set to Sync, so I think the right connections with cables etc are in place.
Any ideas how I need to set the MPC One as a Slave to the ADAT XT Multitrack?
This is the gear I'm using:
MPC > MOTU Midi timepiece II (MIDI patchbay) > JL Cooper Data Master > ADAT XT
Many thanks in advance!
I also have the ADAT XT linked via optical cable to the Yamaha 03D mixer - I often get a YGDAI input SYNC Error with lots of popping from the mixer despite the mixer and ADAT both being set to 48Khz. Any ideas about how to fix this? Do i need some other Word Clock equipment. The mixer and ADAT are only connected via optical cables.