Question for you DigiDesign nuts ;-)

Quick question... after a whole bunch of thinking and thinking, i've finally decided to cop the Mbox... so i did... quick $500 gone!! hopefully it's worth it.... anyway... i'm having a problem, but it's only a problem because i have no clue what the **** i'm doing.... I got the new software, the Pro-Tools 6.1, and since the Mbox doesn't have any Midi's (by the way, what the hale was DigiDesign thinking ?) I have my M-Audio Audiophile hooked up.... I wanna Midi Sync my MPC2000xl up to Pro-Tools, but i have no clue where to go to set Protools to Midi Sync, can one of you pro tools nuts give me some insight and bring this problem to the light?

Click on the MIDI tab> click on midi beat clock> your midi device shoud show up in a list, select it.

Check out this thread for more info, forget about the referances to MTC, just use midi beat clock.

http://www.mpc-forums.com/viewtopic.php?t=5198&highlight=

There is a Pro Tools forum you should check out.

www.digidesign.com

Click "Support", then click "User Conference."

.

MistaMike4u wrote: (by the way, what the hale was DigiDesign thinking ?)

they were thinkin they are hookin you up with an interface and software for under 5 bills, thats a great deal. a basic midi interface costs less than $100.

make sure you have your midi interface drivers loaded too.