This works with all MPC's and also with other versions of Pro Tools highers then 6.1
Configuration of Pro Tools and MPC-2000 and other MPC Models for sync using MIDI Beat Clock and MIDI Time Code on Windows XP Pro Tools 6.9 or Higher.
Configuration of Pro Tools and MPC-2000 for sync using MIDI Beat Clock and MIDI Time Code on Windows.
1) The following setup is for both MTC and MIDI Beat Clock. (When using MTC provide a bar or two of pre-roll)
2) With Pro Tools LE or Pro Tools HD version 6.x, you'll need an interface with MIDI capability such as a MIDI I/O, Digi 002 rack or mixer, Digi 001, or third party MIDI interface.
3) Verify that there is a device created , GO TO Setups menu, MIDI Studio and create a MPC 2000 by clicking "create" choose manufacture and model then the Input Port and Output port on your MIDI interface. Check the properties to check for any preferences to enable MTC or MIDI Beat Clock.
In Pro Tools:
1) go to Setups > Peripherals > Synchronization > Generic MTC > port = DIGI 002 (or, other MIDI Interface of choice)
2) Go to MIDI -> MIDI Beat Clock -> make sure boxes for Enable MIDI Beat Clock and MPC 2000 are filled in.
3) Session setup > Frame Rate =30 and MTC to port = MPC 2000
In the MPC 2000:
1) go to > MIDI Sync> Frame Rate=30, MIDI Clock (stands for MIDI Beat Clock; Choose either MTC or MIDI Beat clock here), receive MMC=off, Port 1 (There are 2 MIDI INS and 2 MIDI outs on the MPC 2000; VERIFY the MIDI cable going from the MIDI interface into either MIDI IN Port 1 or MIDI IN Port 2 corresponds to the Port selected on the MPC 2000's Midi sync menu)
7) press PLAY on the MPC 2000 (it will wait for sync from Pro Tools
8 ) press PLAY on Pro Tools; it will trigger the MPC 2000.
Reason should be running in Rewire, so it should automatically sync when you open Reason up as an Instrument Plug In in Pro Tools
R.I.P. Michael Jackson