Verse track

Hey everyone wassup. Well I finally made a beat (just a rough draft), just a short game sample loop with a basic drum track. The thing is that I chop up my sample in two pieces , one for a chorus and a verse. I already got the chorus handled, but I'm having a little trouble with the verse. I'm basically trying not to make the chorus and verse overlap each other. Anyone got ideas about this? I'd appreciated very much. Thanks.

set pads to mute group

Mute group? Okay I'll take a look at it later on. Thanks.

Mode
Program
Params
Set to MONO in top right corner

this will set the whole program to where everytime you hit a pad, it cuts off any other sample that is playing from that program. or you can set individual pads to mono so that when you play a sample with a pad and you hit the same pad again it will cut off the sound and play the sample again from the beginning.

Or you can set the mute groups within any program to have only certain pads cut each other off

read the manual in regards to mute groups