Q-Link's Broke?

If both my Qlinks are not slid all the way to the bottom, they will start to spaz out anything that is highlighted. For instance, say im about to change the tune on a sample, if i move either of the Qlinks the tuning will rapidly change numbers in no particular order. As for chopping with the Qlinks, there's no way. Once they get spazzin they dont stop unless i have them all the way down.

Any Ideas? They didn't always do this!

btw its a black MPC1000 /w JJoS2XL 2.06

Deoxit. Matter of fact, can we put up a deoxit sticky? Its the first thing everyone should try when buttons, sliders, and encoders start to act funny.

do you have a midi controller with knobs or sliders?
because in the near future you may be able to control qlinks w/ incoming CCs and just remove your qlink board.