loop of a sample doesnt seem to work right ?!

i've made a voicesample and switched on the loopfunction...
then the sample play and loop the last part as long as i've hold down the pad...
then i've made a track where the sample was played at the begining and the loop works fine... but just for a few rounds ... then the sample was played without the loop ...

whats wrong ? please some1 help

FYI: i've got my MPC1k since yesterday

do you have the sound set to "note-off"?

yep... its alright on Note On

and the decay of the event in the track is set to 5000...

ok, now it works fine

the decay of the event seems to be to long... i've changed it to 750, the sample now loop a few times and stop a bit before it is triggert again by the sequence...

but thx for help

"and the decay of the event in the track is set to 5000"

Umm, sounds like you are doing it hard way, that is looping across loop points to fit a sequence. Why not just trigger the section in one-shot mode at each interval?

I may be mistaken here as I've only had the 1000 a few hours now, but doesn't it simplify the use of phrase loops within a sequence by automatically cutting the duration of a held pad to the loop length if the option is set? (P. 19 in the English manual)

I haven't put this option to work yet (been playing with all the internal sounds. There's some nice ones among the muck, though all the preset loop patterns are garbage and sound outdated)

Seems like this makes phrase looping far simpler than in any older MPC.

-tank.