By detroit-mpc
Sat Jan 10, 2004 11:38 pm
Not 100% on the way of the the Q-Link effects faders on the piece. After going over all the privious posts, I was wondering if anyone could shed some light on the issue. I haven't had any problems(so far)with the faders actual functionablity/reliablity, but I don't have the exact usage down yet.
My issue, for example, is when you have the Filter set for either Q1 or Q2, as I adjust the fader from it's highest possition to the lowest possition, it acts as if the fader moves the effect variations twice in one full fade. Does that make sence? Like when you have the setting of -50 to +50, the effect should respond to the movement being -50 at one end of the fader and +50 at the other. My response is different though. It begins at one end and ends in the middle(when the fader is dead on the the middle of the side maker lines)and then begins again and ends at the bottom of the fader.
Someone brought up the fact of having to adjust the percentages for each effect to make them work with what ever style voice you have set in that perticular pad.
Any tips of tricks out there that anyone could share?
Cheers
My issue, for example, is when you have the Filter set for either Q1 or Q2, as I adjust the fader from it's highest possition to the lowest possition, it acts as if the fader moves the effect variations twice in one full fade. Does that make sence? Like when you have the setting of -50 to +50, the effect should respond to the movement being -50 at one end of the fader and +50 at the other. My response is different though. It begins at one end and ends in the middle(when the fader is dead on the the middle of the side maker lines)and then begins again and ends at the bottom of the fader.
Someone brought up the fact of having to adjust the percentages for each effect to make them work with what ever style voice you have set in that perticular pad.
Any tips of tricks out there that anyone could share?
Cheers