Continuous notes?

I was wondering if theres a way to sample a bass note or tone and configure it within a program to play continuously without having to overlap it or have it start and stop again when I play it in a sequence (I tried the latter with a feedback tone I made when sampling and made it long enough to fit in a 2 bar loop, but you could hear when the sound it starting over kind of). Theres a few sounds like the one I'm describing in the internal memory but I'd rather not use them and I'd like to just make my own. thanks~!

you just need to get the loop points right and set the sound to LOOP in trim mode.

in program mode you also need to set the sound to "note-on" instead of "one-shot".

now your sound will play for as long as you hold the pad down.

to get the loop points right in the trim mode you just have to play it back looped (pad 13 i think) while you change the points until you get it just right and don't hear it loop.

so are you saying that you personally have done this technique with any sound you needed...and this has worked?