Post your questions, opinions and reviews of the MPC1000. This forum is for discussion of the OFFICIAL Akai OS (2.1). If you wish to discuss the JJ OS, please use the dedicated JJ OS forum
does anyone have the problem when you turn on the load a program and it plays multiple samples on one pad like say you got something on pad 1 and you got sometihg on pad 10 and they play at the same time thats the only
way i could explain it
anyone?
Posts: 25
Joined: Fri Jan 6th, 2006
Location: jersey
check the program mode and make sure you haven't assigned two samples to the same pad. this is the most likely cause of your woe.
Posts: 49
Joined: Thu Jun 21st, 2007
Location: Leads
Posts: 25
Joined: Fri Jan 6th, 2006
Location: jersey
Posts: 49
Joined: Thu Jun 21st, 2007
Location: Leads
Go to program screen and check which note your pad is assigned to. Maybe you have 2 pads assigned to the same note?
Posts: 223
Joined: Sun Jul 30th, 2006
Location: seattle
By
Sheldon
Sat Jul 07, 2007 2:33 pm
Posts: 438
Joined: Wed Jan 31st, 2007
You might have something shorting out inside the MPC. I've heard reports of people's pad boards coming loose so that when the press one pad, it shorts out (and thus triggers) another pad. I think the fix was to take apart the MPC and tighten the pad board screws. See the pad fix sticky topic for better detail about the workings of the pads.
Valued Member
Posts: 1270
Joined: Sun Dec 4th, 2005
Location: St. Charles, Mo
By
Antonym
Sun Jul 08, 2007 1:42 am
did you make the pgm in bluebox?
Expert Member
Posts: 9969
Joined: Tue Dec 14th, 2004
Location: fairfax, VA
